Displays the trench run curve properties that you can edit or that are automatically determined by the software. The property name displays on the left side of the grid and the corresponding property value displays on the right side of the grid.
Category
Specifies the properties category to view. Select Standard or Weight & CG.
Standard Category
Parent System
Displays the parent trench run system for the curve feature. You cannot change this property.
Name
Displays the name of the curve feature. The name is based on the Naming Rule selection. To type a new name for the trench, select User Defined in the Naming Rule box.
Naming Rule
Specifies the naming rule to use to automatically name the trench. To manually type your own name in the Name box, select User Defined.
Trench Type
Specifies the type of trench. The software inherits this property from the trench run, and you cannot modify it.
You cannot modify the trench type of a trench run after placement.
Minimum Bottom Slope
Displays the minimum slope required for the trench run, as defined in the catalog.
Start Invert Elevation
Specifies the invert elevation at the starting point of the path. Invert elevation is the elevation at the top of the bottom footing of the trench.
End Invert Elevation
Specifies the invert elevation at the end point of the path. Invert elevation is the elevation at the top of the bottom footing of the trench.
Bottom Slope
Displays the slope at the bottom of the trench. The software inherits this property from the trench run, and you cannot modify it.
Top Slope
Specifies the slope at the top of the trench. Type a negative value for a clockwise slope and a positive value for a counter-clockwise slope. The value of the top slope must not exceed 60 horizontal degrees. You can type a value only when the slope is not computed by the software for the selected bottom slope or top slope method.
Trench Length
Specifies the horizontal length of the trench run.
Top Slope Length
Specifies the length measured along the top slope; that is, along the line joining cardinal point 8.
Bottom Slope Length
Specifies the length measured along the bottom slope; that is, along the line joining cardinal point 2.
Radius
Displays the radius of the trench curve feature. The software measures the radius from the sketch segment.
Weight & CG Category
Dry Weight
Specifies the total dry weight of the trench, not including liquid or routed systems that may run through the trench. This value is calculated by the software. The weight for the trench is volume ยด density. The volume is defined under the Volume category of the trench run. The density is read from the catalog for the materials defined on the Start Cross-Section tab.
Wet Weight
Specifies the wet weight of the liquid or routed systems that may run through the trench.
Dry CGX
Specifies the X-axis location of the dry center-of-gravity.
Dry CGY
Specifies the Y-axis location of the dry center-of-gravity.
Dry CGZ
Specifies the Z-axis location of the dry center-of-gravity.
Wet CGX
Specifies the X-axis location of the wet center-of-gravity.
Wet CGY
Specifies the Y-axis location of the wet center-of-gravity.
Wet CGZ
Specifies the Z-axis location of the wet center-of-gravity.