Failed to extend the profile part’s geometry so that mitering could properly be applied. Therefore, the profile (stiffener or beam) part has not been created or updated. (Structural Detailing)
Meaning: This error is related to profile geometry and is usually geometry-specific. The error occurs for some cases in which stiffeners cross over a plate knuckle.
Recovery:
-
Verify that the profile system has proper boundaries. Check for knuckles to split the profile system.
-
Check whether the landing curve of the profile could be modified to avoid knuckles, bends, or complex geometry.
1. Profile part ends by passing over a bend knuckle of the plate.