When you draw the component and have the Graphics Overlay rule set to Overlay in Enhanced Mode or Overlay in Enhanced & Solid Mode, the component displays the same as your original 3D solid.
To see the differences do the following:
-
Type CONVERTENHANCED on the command line, and then press ENTER twice.
-
Click Setup .
If you completed either Create a graphic overlay from a block or Create a graphic overlay from a drawing, then you already have a specification set. However, if you added your overlay using the steps in Assign a graphic overlay to a coupling component in the Specification Editor, then you must set the specification where you updated your coupling component data tables.
-
Click Piping Rules.
-
Set the Graphics Overlay to Disable Overlay.
-
Set the Auto Coupling Rule to Automatic - All Connections.
-
Click Apply and Close.
-
Click Auto Route .
-
Route pipe as shown below:
-
Click Setup .
-
Click Piping Rules.
-
Set the Graphics Overlay to Overlay in Enhanced Mode, or Overlay in Enhanced Mode & Solid Mode.
The coupling component displays with the graphic overlay representation.