Enables you to move, lengthen, or change the elevation of the piping in the plane.
Elevation
Enables you to move the elevation of the piping.
-
Pick
Select the elevation point in the drawing to place the piping.
-
BOP
Places the piping in the elevation based on the Bottom of Pipe.
-
TOP
Places the piping in the elevation based on the Top of Pipe.
-
Select the piping.
The grip points display.
-
Select a grip point .
-
Move the piping as needed.
To move the piping in the elevation, type E on the command line and then follow the prompts. The prompt options are listed above.
If an item is unable to move, a message displays on the command line.