-
Click Openings Command on the vertical toolbar to display the Openings Ribbon.
-
Select the plate system on which to place the opening.
-
Click Define by catalog selection .
The Opening Palette Dialog and the Geometric Construction Explorer dialog display.
-
On the 0SOval tab, click 0SOval 500x250, 0SOval 600x450, or 0SOval 850x500 to display the 0S Fixed Dimension Oval Ribbon.
-
Select a coordinate system.
A local coordinate system at the plate origin displays. A preview of the opening using the fixed length and width displays at the center of the plate. X, Y, and Z display the local coordinates at the center of the plate.
-
If required, type a new value for Angle.
The preview reflects the new parameters.
-
If required, type new X, Y, and Z values.
The preview reflects the new opening location.
-
Click Continue.
The preview colors change. The opening also displays in the Geometric Construction Explorer hierarchy.
-
You can define additional openings before proceeding to the next step. Click Continue after defining each opening.
-
To delete opening geometry, see Delete advanced opening geometry.
-
-
Click Close.
The ribbon display returns to the main Openings Ribbon.
-
Use the Opening design type, Opening planning method, and Opening production method lists to set the design, planning, and production properties on the opening.
-
To delay cutting the plate system, clear Cut to create only the opening geometry.
-
Click Finish.
The software creates the opening.
If you cleared the Cut option on the Openings ribbon, the software creates the opening geometry without cutting the plate system.