The Hold Down support uses the following Shoe 1 attributes:
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
Shoe1Part |
Shoe 1 |
Standard |
No |
Yes |
Shoe1Rule |
Shoe 1 - Rule |
Standard |
No |
Yes |
Shoe1RuleType |
Shoe 1 - Rule Type |
Standard |
No |
Yes |
Shoe1Length |
Shoe 1 Length - Value |
Dimensions |
Yes |
Yes |
Shoe1LengthRule |
Shoe 1 Length - Rule |
Dimensions |
No |
Yes |
Shoe1LengthSelection |
Shoe 1 Length - Selection |
Dimensions |
No |
Yes |
Shoe1LengthDefinition |
Shoe 1 Length - Definition |
Dimensions |
No |
Yes |
Shoe1Height |
Shoe 1 Height - Value |
Dimensions |
Yes |
Yes |
Shoe1HeightRule |
Shoe 1 Height - Rule |
Dimensions |
No |
Yes |
Shoe1HeightSelection |
Shoe 1 Height - Selection |
Dimensions |
No |
Yes |
Shoe1HeightDefinition |
Shoe 1 Height - Definition |
Dimensions |
No |
Yes |
The Hold Down support use the following attributes:
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhs_Shoe1::Shoe1Part |
Specifies the part number to use for the bottom shoe. |
|
IJUAhs_Shoe1Length:: |
Specifies the length of the shoe to override. |
The following definition is supported: 1 - Length of Shoe |
IJUAhs_Shoe1Height:: |
Specifies the height of the shoe to override in the support. |
1 - Height from bottom of the pipe to bottom of Shoe 2 - Height from center of pipe to the bottom of Shoe |
Shoe 2 Attributes
Shoe 2 attributes define the shoe that attaches to the top of the route and display the same behavior and functionality as the Shoe 1 attributes.
If you set a value or if a rule returns a value for Shoe2Height, then the Shoe2Height value is used to offset the top steel member vertically from the pipe and does not require a shoe part. If you do not set a value and a shoe part exists, then the height of the shoe part is used to offset the top steel member.