The following commands are used when working in the Cross Wiring Window.
View > Target Signal
Starts semi-automatic cross-wiring mode to automatically find matching terminals for potential cross wiring.
View > Terminal Connection
Opens the Terminal Connection dialog, where you can examine the connections of the selected terminals.
View > Refresh
Refreshes the data in either the Primary or Secondary data window depending on which one of them is active.
Actions > Auto- Wiring
Starts automatic cross wiring.
Actions > Manual
Returns from the automatic cross wiring mode to manual mode.
Actions > Cross
Executes automatic cross wiring. This icon is active only in automatic cross wiring mode.
Actions > Remove
Removes the cross wiring between selected cross-wired terminals.
Reports > Panel- Strip
Generates a report that shows all the wiring connections of the primary strip on both sides.
Reports > Point-to- Point wiring diagram
Opens a point-to-point wiring diagram where you can view the signal propagation after cross wiring.